Brush Roll ICONpet Robotic Vacuum

Description

Brush Roll for the BISSELL ICONpet Robotic Vacuum.
To maintain the Brush Roll, please follow these steps:
Turn power OFF, remove the robot from the dock and put it upside down on a soft surface.
Use a Phillips-head screwdriver to remove the 3 screws on the sole plate. Rotate the sole plate and lift it out.
Look for damage on the sole plate rollers and flexible wiper. Make sure they’re all rotating freely. Replace if necessary.
Pull up on the plastic end cap to remove the brush. Clean it and make sure the plastic end rotates freely.
Check right side drive gear to remove any hair build up.
Replace Brush Roll.
Holding the sole plate at a slight angle, align the slots in the sole plate with the tabs, then rotate the sole plate into place.
Replace the screws and don’t overtighten. Compress the bumper several times to ensure smooth operation.